DS Audio DS-W2 Optical Cartridge + Equalizer
– Complete set DS Audio W2 cartridge + W2 EQ (black)
– less than 100 hours of use! (verified on preamp timer)
– mint condition, complete with original packing and all accessories
1 op voorraad
World beating optical cartridge technology
The DS-W2 is the successor to our DS-W1 optical cartridge design, which was award- ed the title of world’s best phono cartridge by two major audio magazines in Germany: Stereo and Audio. This praise helped to establish the popularity of our unique technology, setting a high standard and paving the way for further development. The extensive advancements and refinements of the DS-W2 design have resulted in performance that is far in excess of the already impressive DS-W1.
Boron Cantilever with Micro-ridge stylus
The DS-W2 is equipped with a boron cantilever and Micro-Ridge stylus representing a further upgrade from the Shibata stylus used on its predecessor DS-W1.
This combination precisely traces the record groove and yields the utmost quality of sonic reproduction.
A hand-crafted, “Natural Rose quartz” LED indicator adds an eye-catching detail to this unique piece of audio technology.
Upgraded equalizer featuring a sophisticated power supply
The DS-W2 equalizer houses 12 large capacitors, each with 56000μF capacity; more thanthose normally found in a phono pre-amplifier. In use, the benefits of this design choice are obvious, with fantastic musical control and an effortless presentation. A 1.5mm thick pure copper plate bus-bar is employed to connect these capacitors, ensuring maximum power transfer. This also functions as a shielding plate for the transformer, revealing more low-lev- el musical detail.
All of the improvements of the DS-W2 equalizer have created a component three times larger than the predecessor DS-W1, and sonic performance is of an even greater magni- tude. The result is ultimate enjoyment from your record collection.
Expect to hear more from DS Audio.
Fully balanced XLR output
Offering a choice of outputs and low frequency response options, the DS-W2 preamp/equalizer features two sets of RCA and XLR outputs and two separate low frequency cut-off points.
Hand-made in Japan circuit board
Every component part used in our products is tested and evaluated by our expert Japanese technicians.
In addition to using a specially printed circuit board, twist-connection of the compo- nentlegsisfurtherevidenceofDSAudio’ s excellent attention to detail.
Each and every product is hand-made and quality assured by our skilled engineers.
Signal output: Photo-electric Conversion
Channel separation: 25db more(1KHz)
Output signal level: 50mV more
Body material: Aluminum
Needle pressure: 1.6g~1.8g(1.7g is recommended)
Stylus: Micro Ridge
Output voltage: 500mV(1kHz)
Output impedance: RCA 120Ω XLR 600Ω
Pre amp input impedance: More than 10kΩ
Input terminal: RCA terminal
Output terminal: RCA terminal×2,
SOUND ODYSSEY BV